Unique Motorsports

This is the original article from when I built up my original kit in 1999.

Disclaimer: This article is written for information purposes only. In no way do I suggest doing this. If you do… this information should be interpreted as a tool or learning device, not a “how to.” I take no responsibility for what you do on your time. That being said, this information is correct to the best of my knowledge.

Introduction:

After seeing turbo cars pop up in magazines and after owning a 1990 Eagle Talon TSI Turbo, I decided to look into turbo charging the Impreza even more. Once Minnam Racing came out with a turbo kit for the Impreza, I realized that it is possible to feasibly turbocharge an Impreza. At this time the thought of 4 spinning tires, neck-break acceleration, and the quarter mile times of a Porche 911 turbo were mostly just fantasy. Soon after however, something pushed me over the edge. The March 1999 turbo magazine. On page 130 lies Byron’s now 500+ horsepower daily driver Impreza.

(continue reading…)

Finally a chance to build something using melted steel. Not sure what it is about basic fabrication work, but it’s almost always a good time. Add to that, I haven’t actually made anything in a while so it’s nice to keep the skills fresh.

The project started by loading up my welder, 4.5” angle grinder, electric die grinder, wire brush, gloves, welding helmet, porting bits and a few other misc fabrication tools into the Skittle and headed off to James for some work on his Beastly rear wheel drive Impreza.

(continue reading…)