Unique Motorsports

In Part 1 of this 2 part series we removed the bumper cover, the crash bar and the beam. Now it’s time to re-center the tailgate and put everything back together.

It’s been about a month since the actual install so I’ll let the pictures and descriptions do the talking.

Pretty much any car designed for the masses is going to be somewhat neutral in many aspects. Suspension is a great example of this as the average person doesn’t want a firm ride or the worry of breaking the front bumper cover off when getting just a little to snug to a curb. Automotive enthusiasts however, are a slightly different breed. We notice that split second gab between turning the wheel and the car following along. We are ok with a little more noise, we want the car to be firm and responsive.

Springs vs Coilovers – The debate will continue. Personally I say springs. You can get a nice firm responsive whip without being overly jaring. Coilovers really limit the amount of suspension travel you have. For example, you might need to jack up your car 4 inches before the tire leaves the ground. With coilovers, it’s only going to be about an inch. The nice thing about coilovers such as installed here, are the advantages of setting ride height, spring rate and shock firmness.

This install is about coilovers. The install is pretty much the same as a regular spring install with a few key differences.

(continue reading…)

Another spring install on a WRX along with a Downpipe install. This time its a 2009 Impreza WRX Hatchback. Not only do these Epic Lowering Springs give the car a much nicer stance, it’s also a great suspension modification to improve the handling of the WRX without sacrificing ride quality.

Scroll through and click on the images for descriptions of the install.

Installing a pulley on an Subaru with an EJ engine such as the Impreza or Legacy is pretty straight forward. Basically just lock the engine either by putting the car in gear or using something such as my pulley removal tool to lock the engine as you loosen the crank pulley. Once the bolt is loose, work the pulley off and replace with your new lightweight pulley.

No it’s not typo, it’s a brace to brace the brace. Looking a few post back, you will see that I somehow managed to break the transmission where a bolt mounts the torque mount to. That wouldn’t have been so bad if the other bolt didn’t fall out a few months before. The end result was a brace that would actually pivot allowing the engine to twist while power was applied. This in turn would cause the gear lever to pull forward and actually pop out of 1st, 3rd, and 5th gear.
(continue reading…)